Onkyo receivers user manual

When the power-supply cord or plug is damaged,. If liquid has been spilled, or objects have fallen into the apparatus,. If the apparatus has been exposed to rain or water,.

If the apparatus does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the apparatus to its normal operation,.

If the apparatus has been dropped or damaged in any way, and. When the apparatus exhibits a distinct change in performance this indicates a need for service.

Never push objects of any kind into the apparatus through openings as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock.

The apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases shall be placed on the apparatus. Always consider the environmental issues and follow local regulations when disposing of batteries. If you install the apparatus in a built-in installation, such as a bookcase or rack, ensure that there is adequate ventilation.

Leave 20 cm 8" of free space at the top and sides and 10 cm 4" at the rear. The rear edge of the shelf or board above the apparatus shall be set 10 cm 4" away from the rear panel or wall, creating a flue-like gap for warm air to escape.

If you cannot turn on the unit, contact your Onkyo dealer. Care —Occasionally you should dust the unit all over with a soft cloth. For stubborn stains, use a soft cloth dampened with a weak solution of mild detergent and water. Dry the unit immediately afterwards with a clean cloth.

AC outlet voltages vary from country to country. The power cord plug is used to disconnect this unit from the AC power source. Make sure that the plug is readily operable easily accessible at all times.

If you do not intend to use the unit for an extended period, remove the power cord from the AC outlet. Preventing Hearing Loss Caution. Batteries and Heat Exposure Warning. Batteries battery pack or batteries installed shall not be exposed to excessive heat as sunshine, fire or the like.

Never Touch this Unit with Wet Hands —Never handle this unit or its power cord while your hands are wet or damp. If water or any other liquid gets inside this unit, have it checked by your Onkyo dealer. This is normal. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:.

If liquid is spilled over the speakers, the drive units may be damaged. Putting them on uneven or unstable surfaces, where they may fall and cause damage, will affect the sound quality.

Do not use it in the horizontal or tilted position. TVs and computer monitors are magnetically sensitive devices and as such are likely to suffer discoloration or picture distortion when conventional speakers are placed nearby. In such situations, try moving the speakers away from your TV or monitor. If discoloration should occur, turn off your TV or monitor, wait 15 to 30 minutes, and then turn it back on again. This normally activates the degaussing function, which neutralizes the magnetic field, thereby removing any discoloration effects.

The speakers can handle the specified input power when used for normal music reproduction. If any of the following signals are fed to them, even if the input power is within the specified rating, excessive current may flow in the speaker coils, causing burning or wire breakage:. Interstation noise from an untuned FM radio.

Sound from fast-forwarding a cassette tape. High-pitched sounds generated by an oscillator, electronic musical instrument, and so on. Special test tones from audio test CDs and so on.

Thumps and clicks caused by connecting or disconnecting audio cables always turn off your amplifier before connecting or disconnecting cables. Specifications and operations are the same regardless of color.

Zone Manufactured under license under U. Product includes software. Manufactured under license from Dolby Laboratories. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards. The actual front panel has various logos printed on it. They are not shown here for clarity. The page numbers in parentheses show where you can find the main explanation for each item. If the Auto Standby function does not work reliably, try slightly increasing or decreasing the subwoofer output level on the AV receiver These keyhole slots can be used to wall-mount the speaker.

These push terminals are for connecting the speaker to the HT-R with the supplied speaker cables. The supplied speaker cables are color-coded for easy identification. Simply connect each cable to the samecolored positive speaker terminal. For detailed information, see the pages in parentheses. TUN button These output the overall sound. Their role in a home theater is to provide a solid anchor for the sound image.

They should be positioned facing the listener at about ear level, and equidistant from the TV. Angle them inward so as to create a triangle, with the listener at the apex.

This speaker enhances the front speakers, making sound movements distinct and providing a full sound image. Position it close to your TV facing forward at about ear level, or at the same height as the front speakers. These speakers are used for precise sound positioning and to add realistic ambience. Position them at the sides of the listener, or slightly behind, about 2 to 3 feet 60 to cm above ear level.

Ideally they should be equidistant from the listener. The volume and quality of the bass output from your subwoofer will depend on its position, the shape of your listening room, and your listening position. In general, a good bass sound can be obtained by installing the subwoofer in a front corner, or at one-third the width of the wall, as shown.

They enhance the realism of surround sound and improve sound localization behind the listener. Position them behind the listener about 2 to 3 feet 60 to cm above ear level.

They significantly enhance the spatial experience. Position them at least 3. Before you connect the speakers, attach the supplied speaker base to each SKF Turn the speaker upside down with the protection cover attached. Be careful not to tip over the speaker. Align the screw holes on the speaker base with those on the bottom of each speaker, and affix the speaker base using the supplied screws.

Turn the speaker right side up. Remove the protection cover. MiniDisc Player Manuals. MP3 Docking Station Manuals. MP3 Player Manuals. MP3 Player Accessories Manuals. Musical Table Manuals. Network Cables Manuals. Network Card Manuals. Network Hardware Manuals. Portable CD Player Manuals. Portable Speaker Manuals. Radio Manuals. Satellite Radio Manuals. Speaker Manuals. Speaker System Manuals. Stereo Amplifier Manuals.

Portable Speaker Manuals. Radio Manuals. Satellite Radio Manuals. Speaker Manuals. Speaker System Manuals. Stereo Amplifier Manuals. Stereo Receiver Manuals. Stereo System Manuals. Turntable Manuals. TV Cables Manuals.

Universal Remote Manuals. Video Game Sound System Manuals. Forgot your password? Sign up now. Sign Up.